Toyota Camry owners & service manuals

Toyota Camry (XV70): Inspection

Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / A25a-fks (cooling) / Flow Shutting Valve(for Heater) / Inspection

INSPECTION

PROCEDURE

1. INSPECT FLOW SHUTTING VALVE (WATER BY-PASS HOSE ASSEMBLY)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - 2

20°C (68°F)

22 to 28 Ω

If the result is not as specified, replace the flow shutting valve (water by-pass hose assembly).

*a

Component without harness connected

(Flow Shutting Valve (Water By-pass Hose Assembly))

    READ NEXT:

     Installation

    INSTALLATION PROCEDURE 1. INSTALL FLOW SHUTTING VALVE (WATER BY-PASS HOSE ASSEMBLY) (a) Connect the flow shutting valve (water by-pass hose assembly) to the transmission oil cooler and slide the cli

     Radiator

     Components

    COMPONENTS ILLUSTRATION *1 FRONT WHEEL OPENING EXTENSION PAD LH *2 FRONT WHEEL OPENING EXTENSION PAD RH *3 NO. 1 ENGINE UNDER COVER *4 NO. 2 ENGINE UNDER COVER AS

    SEE MORE:

     Terminals Of Ecu

    TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY *A w/o Seat Heater System *B w/ Seat Heater System *C Dual Type Automatic Air Conditioning System *D Single Type Automatic Air Conditioning System (a) Disconnect the K54 air conditioning ampl

     On-vehicle Inspection

    ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (a) Connect the Techstream to the DLC3. (b) Start the engine. (c) Turn the Techstream on. (d) Inspect the camshaft timing oil control solenoid assembly (for intake side). (1) Enter the following menus: Pow

    © 2023-2026 Copyright www.tocamry.com