Toyota Camry (XV70): Installation
INSTALLATION
PROCEDURE
1. INSTALL VACUUM SWITCHING VALVE (for Active Control Engine Mount System)
(a) Install the vacuum switching valve (for active control engine mount system) to the front engine mounting insulator with the nut.
Torque:
6.0 N·m {61 kgf·cm, 53 in·lbf}
(b) Connect the 3 vacuum hoses to the vacuum switching valve (for active control engine mount system).
(c) Engage the wire harness clamp and connect the vacuum switching valve (for active control engine mount system) connector.
(d) Install the 2 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
(e) Engage the wire harness clamp and install the engine wire with the bolt.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
2. INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
Click here .gif)
3. INSTALL INLET AIR CLEANER ASSEMBLY
Click here
4. INSTALL COOL AIR INTAKE DUCT SEAL
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 VENTILATION HOSE
*2 PURGE VALVE (PURGE VSV)
*3 NO. 1 FUEL VAPOR FEED HOSE
*4 NO. 2 SURGE TANK STAY
*5 INTAKE AIR SURGE TANK A
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT FUEL CUT OPERATION (a) Start the engine. (b) Warm up the engine.
(c) Increase the engine speed to approximately 3500 rpm. (d) Use a sound scope to check for fuel injector assembly operating sounds.
(e) When the accelerator pedal is fully released, che
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE FRONT WHEEL Click here
2. SEPARATE FRONT FLEXIBLE HOSE
Click here 3. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBL
