Toyota Camry (XV70): Vacuum Switching Valve (for Engine Mounting)
Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / 2gr-fks (engine Control) / Vacuum Switching Valve (for Engine Mounting)
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
*2 COOL AIR INTAKE DUCT SEAL
*3 INLET AIR CLEANER ASSEMBLY
*4 VACUUM SWITCHING VALVE (for Ac
Removal
REMOVAL PROCEDURE 1. REMOVE COOL AIR INTAKE DUCT SEAL
Click here
2. REMOVE INLET AIR CLEANER ASSEMBLY
Click here
3. REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE Click here
Inspection
INSPECTION PROCEDURE 1. INSPECT VACUUM SWITCHING VALVE (for Active Control Engine Mount System)
(a) Measure the resistance.
(1) Measure the resistance according to the value(s) in the table be
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
(a) Install a new gasket to the water inlet with thermostat sub-assembly.
(b) Install the water inlet with thermostat sub-assembly with the 2 bolts and 2 nuts.
Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} 2. CONNECT WATER
Terminals Of Ecu
TERMINALS OF ECU CHECK TIRE PRESSURE WARNING ECU AND RECEIVER
(a) Disconnect the R127 or R128 tire pressure warning ECU and receiver connector and measure the voltage or resistance on the wire harness side.
*A w/ Smart Key System
*B w/o Smart Key System
*a Front vi
© 2023-2026 Copyright www.tocamry.com
