Toyota Camry (XV70): Installation
Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / 2gr-fks (starting) / Engine Switch / Installation
INSTALLATION
PROCEDURE
1. INSTALL ENGINE SWITCH
(a) Engage the 2 claws to install the engine switch to the lower instrument panel finish panel assembly.
2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
Click here
.gif)
3. INSTALL NO. 1 METER HOOD CLUSTER
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 ENGINE SWITCH
*2 LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
*3 NO. 1 METER HOOD CLUSTER
- -
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 METER HOOD CLUSTER
Click here
2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Click here
3. REMOVE ENGINE SWITCH
(a) Disengage the 2 cla
Inspection
INSPECTION PROCEDURE 1. INSPECT ENGINE SWITCH
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connecti
SEE MORE:
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE BRAKE MASTER CYLINDER STRAIGHT PIN
(a) Secure the brake master cylinder sub-assembly in a vise. NOTICE:
Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.
(b) Using a 5 mm pin punch and a hammer, tap out the brake
Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)
CAUTION / NOTICE / HINT NOTICE: After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and system information memorization.
Click here
PROCEDURE
1.
PRE-INSPECTION (a) Brake pedal inspection
(1) Perform a visual inspec
© 2023-2026 Copyright www.tocamry.com
