Toyota Camry (XV70): Engine Switch
Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / 2gr-fks (starting) / Engine Switch
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 ENGINE SWITCH
*2 LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
*3 NO. 1 METER HOOD CLUSTER
- -
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 METER HOOD CLUSTER
Click here
2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Click here
3. REMOVE ENGINE SWITCH
(a) Disengage the 2 cla
Inspection
INSPECTION PROCEDURE 1. INSPECT ENGINE SWITCH
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connecti
SEE MORE:
Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)
DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH.
HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis inspection is performed. Completing the beam ax
Engine Coolant Temperature Sensor 1 Signal Stuck in Range (P01152A)
DESCRIPTION Refer to DTC P011511. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Memory
Note P01152A
Engine Coolant Temperature Sensor 1 Signal Stuck in Range
Either of the following conditions is met (2 trip detection logic)
© 2023-2025 Copyright www.tocamry.com
