Toyota Camry (XV70): Lost Communication with Brake System Control Module (U0129)
DESCRIPTION
The tire pressure warning ECU and receiver receives signals from the skid control ECU (brake actuator assembly) via CAN communication system.
|
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
Note |
| U0129 |
Lost Communication with Brake System Control Module |
Lost communication with skid control ECU (brake actuator assembly) |
- CAN communication system
- Skid control ECU (brake actuator assembly)
| w/ Tire Inflation Pressure Display Function |
PROCEDURE
| 1. |
GO TO CAN COMMUNICATION SYSTEM |
(a) Go to CAN communication system.
Click here
| NEXT |
| END |
READ NEXT:
DESCRIPTION If the tire pressure warning ECU and receiver detects any problems, the tire pressure warning light blinks for 1 minute then illuminates, and tire pressure monitoring is disabled at the sa
DESCRIPTION The tire pressure warning ECU and receiver identifies the tire position for each tire pressure warning valve and transmitter according to the wheel speed signals from the skid control ECU
DESCRIPTION When "Change Wheel" is selected on the multi-information display and the "OK" switch (steering pad switch assembly) is pushed and held, the system enters ID registration mode and the tire
SEE MORE:
INSTALLATION PROCEDURE 1. INSTALL SLIDING ROOF HOUSING ASSEMBLY
(a) Loosen the 4 bolts of the brackets of the sliding roof housing assembly.
(b) Temporarily install the sliding roof housing assembly with the 6 nuts and 8 bolts.
(c) Tighten the 2 nuts.
HINT: Tighten the 2 nuts in the ord
INSPECTION PROCEDURE 1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
NOTICE: Both the park/neutral position switch assembly and transmission control shaft lever are available in two different shapes due to design changes. As they are not compatible with each other, when replacing the park/neutral