Toyota Camry (XV70): Parts Location
PARTS LOCATION
ILLUSTRATION
|
*1 | ECM |
*2 | ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK ASSEMBLY - ST RELAY - EFI-MAIN NO. 1 FUSE - J/B-B FUSE - ETCS FUSE |
ILLUSTRATION
|
*A | w/ Shift Paddle Switch |
- | - |
|
*1 | SHIFT LOCK CONTROL UNIT ASSEMBLY - TRANSMISSION CONTROL SWITCH |
*2 | SHIFT PADDLE SWITCH LH (TRANSMISSION SHIFT SWITCH ASSEMBLY) |
|
*3 | SHIFT PADDLE SWITCH RH (TRANSMISSION SHIFT SWITCH ASSEMBLY) |
*4 | SPIRAL CABLE SUB-ASSEMBLY |
|
*5 | STOP LIGHT SWITCH ASSEMBLY |
*6 | NO. 1 SWITCH WIRE |
|
*7 | COMBINATION METER ASSEMBLY |
*8 | DLC3 |
|
*9 | ELECTRIC PARKING BRAKE SWITCH ASSEMBLY (COMBINATION SWITCH) - SPORT MODE SWITCH - NORMAL MODE SWITCH |
*10 | INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - STOP FUSE - ECU-ACC FUSE - BKUP LP FUSE |
ILLUSTRATION
|
*1 | SOLENOID (SL1) VALVE |
*2 | SOLENOID (SL2) VALVE |
|
*3 | SOLENOID (SL3) VALVE |
*4 | SOLENOID (SL4) VALVE |
|
*5 | SOLENOID (SL5) VALVE |
*6 | SOLENOID (SL6) VALVE |
|
*7 | SOLENOID (SL) VALVE |
*8 | SOLENOID (SLU) VALVE |
|
*9 | SOLENOID (SLT) VALVE |
*10 | TRANSMISSION WIRE - ATF TEMPERATURE SENSOR |
ILLUSTRATION
|
*1 | PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
*2 | TRANSMISSION REVOLUTION SENSOR (NT) |
|
*3 | TRANSMISSION REVOLUTION SENSOR (NC) |
- | - |
READ NEXT:
System Diagram
SYSTEM DIAGRAM
System Description
SYSTEM DESCRIPTION SYSTEM DESCRIPTION (a) The Electronic Controlled Automatic Transaxle (ECT) is an automatic transaxle that electronically controls shift timing using the ECM. The ECM detects electri
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
The ECM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there are no malfunctions in the CAN commu
SEE MORE:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Automatic Transaxle System
DTC No. Detection Item
MIL Memory
Note Link
P050031 Vehicle Speed Sensor "A" No Signal
Comes on DTC stored
SAE Code: P0500
P056014 System Voltage Circuit Short to Ground or Open
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT
NOTICE: Before installation of each part, thoroughly clean and dry it. Then apply grease or oil as necessary. Do not use alkaline chemicals to clean aluminum parts, rubber parts or precoated bolts. Also, do not use non-residue solvent or other cleaning oils to c
