Toyota Camry owners & service manuals

Toyota Camry (XV70): Poor Sound Quality in All Modes (Low Volume)

Toyota Camry Repair Manual XV70 (2018-2024) / Audio, Visual, Telematics / Navigation / Multi Info Display / Navigation System / Poor Sound Quality in All Modes (Low Volume)

PROCEDURE

1.

CHECK AUDIO SETTINGS

(a) Set treble, middle and bass to the initial values and check that the sound is normal.

OK:

The sound returns to normal.

HINT:

Sound quality adjustment measures vary according to the type of amplifier.

OK

END
NG

2.

COMPARE WITH ANOTHER VEHICLE OF SAME MODEL

(a) Compare with another vehicle of the same model which is not malfunctioning to see if there is any difference in the sound quality.

OK:

No difference is found.

OK

END
NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    READ NEXT:

     Cursor or Map Rotates when Vehicle Stopped

    PROCEDURE 1. CHECK CONDITION (a) Check with the customer if the vehicle has been turned by a turntable. OK: Vehicle has not been turned by a turntable. HINT: If the vehicle is

     "No GPS signal" mark is displayed

    CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to

     Voice Guidance does not Function

    WIRING DIAGRAM PROCEDURE 1. CHECK VOICE GUIDANCE SETTING (a) Check that the voice guidance settings are not off. OK: Voice guidance settings are not off. NG CHANGE VOICE

    SEE MORE:

     Evaporative Emission System Leak Detected (Large Leak) (P045500,P045600)

    DTC SUMMARY DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P045500 Evaporative Emission System Leak Detected (Large Leak) Leak detection pump creates negative pressure (vacuum) in EVAP system and EVAP system pressure is measured

     Precaution

    PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Lane Tracing Assist System

    © 2023-2026 Copyright www.tocamry.com