Toyota Camry owners & service manuals

Toyota Camry (XV70): Cursor or Map Rotates when Vehicle Stopped

Toyota Camry Repair Manual XV70 (2018-2024) / Audio, Visual, Telematics / Navigation / Multi Info Display / Navigation System / Cursor or Map Rotates when Vehicle Stopped

PROCEDURE

1.

CHECK CONDITION

(a) Check with the customer if the vehicle has been turned by a turntable.

OK:

Vehicle has not been turned by a turntable.

HINT:

If the vehicle is turned on a turntable with the engine switch on (IG), the system may store the angular velocity. As a result, the vehicle position cursor may deviate. In this case, the vehicle position cursor will return to normal by turning the engine switch off and back to on (IG) again with the vehicle completely stopped.
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

TURN ENGINE SWITCH ON (IG) WHEN VEHICLE IS COMPLETELY STOPPED

    READ NEXT:

     "No GPS signal" mark is displayed

    CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to

     Voice Guidance does not Function

    WIRING DIAGRAM PROCEDURE 1. CHECK VOICE GUIDANCE SETTING (a) Check that the voice guidance settings are not off. OK: Voice guidance settings are not off. NG CHANGE VOICE

     Route cannot be Calculated

    PROCEDURE 1. SET DESTINATION (a) Set another destination and check if the system can calculate the route correctly. OK: Route can be correctly calculated. OK END NG

    SEE MORE:

     Software Incompatibility with Body Control Module Invalid/Incompatible Software Component (U032257)

    DESCRIPTION If the vehicle information stored in the forward recognition camera does not match the vehicle information sent from the main body ECU (multiplex network body ECU), the forward recognition camera stores DTC U032257. DTC No. Detection Item DTC Detection Condition Trouble Ar

     Inspection

    INSPECTION PROCEDURE 1. INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD NOTICE: Make the adjustment with no vacuum in the brake booster assembly. (Depress the brake pedal several times with the engine stopped.) HINT: Adjustment of the brake booster push rod is required when the brake master cylind

    © 2023-2026 Copyright www.tocamry.com