Toyota Camry (XV70): Precaution

Toyota Camry Repair Manual XV70 (2018-2024) / Brake / Brake System (other) / Brake System / Precaution

PRECAUTION

NOTICE:

This vehicle is equipped with an SRS (Supplemental Restraint System). Failure to carry out service operations in the correct sequence could cause the SRS to unexpectedly deploy during servicing. This may cause a serious accident. Before servicing (including inspection, replacement, removal, and installation of parts), be sure to read the precautionary notices for the Supplemental Restraint System.
Click here
Care must be taken to replace each part properly as it could affect the performance of the brake system and result in a driving hazard. Replace the parts with those having the same part number or equivalent.
It is very important to keep parts and the area clean when repairing the brake system.
If the vehicle is equipped with a mobile communication system, refer to the precautions in the Introduction section.
Click here

SEE MORE:

Installation

INSTALLATION PROCEDURE 1. INSTALL NO. 1 VACUUM SWITCHING VALVE ASSEMBLY (for ACIS) (a) Install the No. 1 vacuum switching valve assembly (for ACIS) to the intake air surge tank assembly with the bolt. Torque: 9.0 N·m {92 kgf·cm, 80 in·lbf} (b) Connect the 2 vacuum hose sub-assemblies to the

Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front stabilizer bar removal/installation are shown below. Necessary Procedures After Parts Removed/I

Toyota Camry (XV70): Precaution

READ NEXT:

Problem Symptoms Table

Brake Vacuum Hose

Vacuum Pump (for 2gr-fks)

SEE MORE:

Installation

Removal