Toyota Camry (XV70): Precaution
PRECAUTION
HINT:
- Any digits beyond the 1/100 mm (1/1000 in.) place for standard, minimum and maximum values should be used as a reference only.
- When both standard and maximum or minimum values are listed for an inspection, use the standard value as a reference only and base any judgments on the maximum and minimum values.
READ NEXT:
COMPONENTS ILLUSTRATION
*A w/ Stud Bolt
- -
*1 VALVE SPRING RETAINER LOCK
*2 VALVE SPRING RETAINER
*3 INNER COMPRESSION SPRING
*4 INTAKE VALVE S
DISASSEMBLY CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced duri
INSPECTION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for bank 1 and bank 2.
The following procedure is for bank 2.
PROCEDURE 1. INSPECT CYLINDER HEAD LH (a) Using a precision
SEE MORE:
TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)
(a) Disconnect the V2 sliding roof ECU (sliding roof drive gear sub-assembly) connector.
(b) Measure the resistance and voltage according to the value(s) in the table below.
HINT: Measure the values on the wire
DATA LIST / ACTIVE TEST READ DATA LIST HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may