Toyota Camry (XV70): Reassembly
REASSEMBLY
PROCEDURE
1. TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG
(a) Temporarily install the rear disc brake bleeder plug to the rear disc brake cylinder.
HINT:
Fully tighten the rear disc brake bleeder plug after bleeding the system.
2. INSTALL REAR DISC BRAKE BLEEDER PLUG CAP
(a) Install the rear disc brake bleeder plug cap to the rear disc brake bleeder plug.
3. INSTALL PISTON SEAL
(a) Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal.
.png) |
Lithium Soap Base Glycol Grease |
(b) Install the piston seal to the rear disc brake cylinder.
NOTICE:
Securely install the piston seal to the groove of the rear disc brake cylinder.
4. INSTALL REAR DISC BRAKE PISTON
(a) Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot.
|
*1 | Cylinder Boot |
|
*2 | Rear Disc Brake Piston |
|
|
Lithium Soap Base Glycol Grease |
(b) Install the cylinder boot to the rear disc brake piston.
(c) Apply a light layer of lithium soap base glycol grease to the contact surfaces of the rear disc brake piston, and install it to the rear disc brake cylinder.
NOTICE:
Do not install the rear disc brake piston forcibly in the rear disc brake cylinder.
5. INSTALL CYLINDER BOOT
|
(a) Install the cylinder boot to the rear disc brake cylinder. NOTICE: Securely install the cylinder boot to the groove of the rear disc brake cylinder and rear disc brake piston. |
|
(b) Using a screwdriver with its tip wrapped with protective tape, install a new rear disc brake piston set ring.
NOTICE:
- Securely install the rear disc brake piston set ring to the outer groove of the cylinder boot.
- Do not damage the cylinder boot.
READ NEXT:
Installation
INSTALLATION CAUTION / NOTICE / HINT
NOTICE:
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attentio
Rear Brake Flexible Hose(w/ Electric Parking Brake System)
ComponentsCOMPONENTS ILLUSTRATION
*1 REAR FLEXIBLE HOSE
*2 GASKET
*3 UNION BOLT
*4 BRAKE LINE
Tightening torque for "Major areas involving basic ve
Rear Brake Flexible Hose(w/o Electric Parking Brake System)
ComponentsCOMPONENTS ILLUSTRATION
*1 REAR FLEXIBLE HOSE
*2 GASKET
*3 UNION BOLT
- -
Tightening torque for "Major areas involving basic vehicle perf
SEE MORE:
Throttle/Pedal Position Sensor/Switch "B" Circuit Short to Ground (P022011)
DESCRIPTION Refer to DTC P012011. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Memory
Note P022011
Throttle/Pedal Position Sensor/Switch "B" Circuit Short to Ground
The output voltage of VTA2 is less than 2.05 V for 2 secon
O2 Sensor Slow Response - Rich to Lean Bank 1 Sensor 1 (P014C00-P014F00,P015A00-P015D00)
DESCRIPTION Refer to DTC P219519. Click here
HINT: Although the DTC titles say oxygen sensor, these DTCs relate to the air fuel ratio sensor.
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Memory
Note P014C00
O2 Sensor Slow Response - Rich to
