Toyota Camry (XV70): Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR DOOR ARMREST COVER SUB-ASSEMBLY
Click here .gif)
2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
Click here
3. REMOVE REAR ARMREST ASSEMBLY
Click here
4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
Click here
5. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP
Click here
6. REMOVE REAR DOOR NO. 2 SERVICE HOLE COVER
Click here
7. REMOVE REAR SPEAKER ASSEMBLY
NOTICE:
Do not touch the speaker cone.
| (a) Disconnect the connector. |
|
(b) Remove the 3 screws.
|
(c) Disengage the 2 guides to remove the rear speaker assembly. |
|
READ NEXT:
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR SPEAKER ASSEMBLY (for 6 Speakers)
(a) With the speaker installed, check that there is no looseness or other abnormalities.
(b) Check that there is no foreign m
Installation
INSTALLATION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL REAR SPEAKER ASSEMBLY
NO
SEE MORE:
Sliding Roof ECU Communication Stop (B1273)
DESCRIPTION This DTC is stored when LIN communication between the sliding roof ECU (sliding roof drive gear sub-assembly)*1 or sliding roof ECU (sliding roof drive gear assembly)*2 and main body ECU (multiplex network body ECU) stops for 10 seconds or more.
DTC No. Detection Item
DTC De
Terminals Of Ecm
TERMINALS OF ECM
HINT: The standard voltage, resistance and waveform between each pair of the ECM terminals is shown in the table below. The appropriate conditions for checking each pair of the terminals is also indicated. The result of checks should be compared with the standard voltage, resista
© 2023-2026 Copyright www.tocamry.com
