Toyota Camry (XV70): Software Incompatibility with Body Control Module Invalid/Incompatible Software Component (U032257)
DESCRIPTION
If the vehicle information stored in the forward recognition camera does not match the vehicle information sent from the main body ECU (multiplex network body ECU), the forward recognition camera stores DTC U032257.
|
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
DTC Output from |
|---|---|---|---|---|
|
U032257 | Software Incompatibility with Body Control Module Invalid/Incompatible Software Component |
The vehicle information sent from the main body ECU (multiplex network body ECU) does not match that stored in the forward recognition camera. |
Front camera system | Radar Cruise2 |
PROCEDURE
| 1. |
CHECK FRONT CAMERA SYSTEM |
(a) Check the front camera system.
Click here .gif)
HINT:
If DTC U032257 is output by the dynamic radar cruise control system, perform troubleshooting for the front camera system.
| NEXT | .gif) | END |
READ NEXT:
Invalid Data Received from ECM/PCM "A" Invalid Serial Data Received (U040181)
DESCRIPTION If the ECM cannot recognize the forward recognition camera. DTC U040181 is stored.
DTC No. Detection Item
DTC Detection Condition Trouble Area
DTC Output from
U
Steering Pad Switch Circuit
DESCRIPTION
The steering pad switch assembly outputs the on/off signal and various control signals to the ECM.
The ECM performs cruise control according to the signals received from the stee
Distance Control Switch Circuit
DESCRIPTION The vehicle-to-vehicle distance control switch is used to set the distance for vehicle-to-vehicle distance control mode. The vehicle-to-vehicle distance control switch is installed in the
SEE MORE:
Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)
DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH.
HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis inspection is performed. Completing the beam ax
Front Camera Module Communication Stop Mode
DESCRIPTION
Detection Item Symptom
Trouble Area Front Camera Module Communication Stop Mode
Any of the following conditions are met:
Communication stop for "Front Camera Module" is indicated on the "Communication Bus Check" screen of the Techstream.
Click here
