Toyota Camry (XV70): Steering Angle Sensor Module Component Internal Failure (C052696)

Toyota Camry Repair Manual XV70 (2018-2024) / Brake / Brake Control / Dynamic Control Systems / Vehicle Stability Control System (w/ Electric Parking Brake System) / Steering Angle Sensor Module Component Internal Failure (C052696)

DESCRIPTION

This DTC is stored when the skid control ECU (brake actuator assembly) receives an internal malfunction signal from the steering angle sensor.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area
C052696	Steering Angle Sensor Module Component Internal Failure	With the +BS terminal voltage between 9.6 and 16.5 V, a steering angle sensor internal malfunction signal is received from the steering angle sensor.	Steering angle sensor

PROCEDURE

1.	REPLACE STEERING ANGLE SENSOR

(a) Replace the steering angle sensor.

Click here

END

SEE MORE:

Components

COMPONENTS ILLUSTRATION *1 FRONT FENDER APRON SEAL RH *2 V-BANK COVER SUB-ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Side of Bank 1) *2 CAMSHAFT TIMIN

Inspection

INSPECTION CAUTION / NOTICE / HINT NOTICE: When using a vise, place aluminum plates between the part and vise. When using a vise, do not overtighten it. PROCEDURE 1. INSPECT REAR DRIVE SHAFT ASSEMBLY (a) Check that there is no excessive play in the radial direction of the outboar

Toyota Camry (XV70): Steering Angle Sensor Module Component Internal Failure (C052696)

READ NEXT:

ABS Pump Motor Control Circuit Short to Ground (C052C11,C052C13,C052F14,C142719)

ABS Pump Motor Control Internal Electronic Failure (C052C49)

Brake Pressure Sensor "A" Circuit Voltage Out of Range (C05401C,C054028,C054049)

SEE MORE:

Components

Inspection