Toyota Camry owners & service manuals

Toyota Camry (XV70): Stereo Component Amplifier Malfunction (B15A3)

Toyota Camry Repair Manual XV70 (2018-2024) / Audio, Visual, Telematics / Navigation / Multi Info Display / Navigation System / Stereo Component Amplifier Malfunction (B15A3)

DESCRIPTION

This DTC is stored when a malfunction occurs in the stereo component amplifier assembly.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B15A3

Stereo Component Amplifier Malfunction

When any of the following conditions is met:

  • Internal power supply malfunction
  • DSP error
  • EEPROM error

Stereo component amplifier assembly

PROCEDURE

1.

CHECK DTC

(a) Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs

(b) Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY

    READ NEXT:

     Navigation Processor Malfunction (B15AD)

    DESCRIPTION These DTCs are stored when a malfunction occurs in the navigation ECU. DTC No. Detection Item DTC Detection Condition Trouble Area B15AD Navigation Processor Malfu

     GPS Antenna Connection Malfunction(short) (B15C0,B15C1)

    DESCRIPTION These DTCs are stored when a malfunction occurs in the navigation antenna assembly. DTC No. Detection Item DTC Detection Condition Trouble Area B15C0 GPS Antenna C

     Speed Signal Malfunction (B15C2)

    DESCRIPTION The navigation ECU receives a vehicle speed signal from the combination meter assembly and information from the navigation antenna assembly, and then adjusts the vehicle position on the ma

    SEE MORE:

     Test Mode Procedure

    TEST MODE PROCEDURE TEST MODE (SIGNAL CHECK MODE) PROCEDURE HINT: When entering test mode (signal check mode), the tire pressure warning ECU and receiver sets all the test mode (signal check mode) DTCs first. After the tire pressure warning ECU and receiver completes the signal check for eac

     Inspection

    INSPECTION PROCEDURE 1. INSPECT MASS AIR FLOW METER SUB-ASSEMBLY (a) Perform a visual check for any foreign matter on the intake air temperature sensor (thermistor) of the mass air flow meter sub-assembly shown in the illustration. OK: There is no foreign matter. If the result is not as sp

    © 2023-2026 Copyright www.tocamry.com