Toyota Camry (XV70): Utility
UTILITY
NOTICE:
When the forward recognition camera has been replaced due to a lane tracing assist system malfunction, failure to adjust the forward recognition camera optical axis may affect all the systems using the forward recognition camera.
HINT:
Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.
One Time Recognition: Click here .gif)
Sequential Recognition: Click here
Driving Adjustment: Click here
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
NOTICE:
When replacing the forward recognition camera, replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the infor
Terminals Of Ecu
TERMINALS OF ECU
NOTICE:
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.
Diagnosis System
DIAGNOSIS SYSTEM DIAGNOSIS MODE FUNCTION (a) When a malfunction occurs in the lane tracing assist system, the LTA indicator light illuminates in yellow and a message is displayed on the multi-informat
SEE MORE:
Does not Recognize Voice Commands Performed to Contact Support Center
PROCEDURE
1. CHECK COMMUNICATION BASED VOICE RECOGNITION FUNCTION
(a) While paying attention to the condition of the spoken voice command, say "Find a gas station in New York" and check that voice recognition is operating normally.
HINT:
When the voice command is recognized, the
Utility
UTILITY INITIALIZE THE CONNECTION INFORMATION OF A GATEWAY FUNCTION EQUIPPED ECU (BUS MONITOR ECU)
(a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON.
(c) Turn the Techstream on. (d) Enter the following menus:
for Body Electrical / Central Gateway / Utility / Initial
© 2023-2025 Copyright www.tocamry.com
