Toyota Camry (XV70): Brake Vacuum Hose
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*A for A25A-FKS
- -
*1 NO. 1 VACUUM HOSE CONNECTOR
*2 UNION TO CHECK VALVE HOSE
*3 VACUUM HOSE
*4 CLIP ILLUSTRATION
Removal
REMOVAL PROCEDURE 1. REMOVE UNION TO CHECK VALVE HOSE (for A25A-FKS)
(a) Slide the clip and disconnect the union to check valve hose from the brake booster assembly.
(b)
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 1 VACUUM HOSE CONNECTOR (for A25A-FKS)
(a) Align the No. 1 vacuum hose connector with the vacuum pump assembly, and push them together until the No. 1 vacuum ho
SEE MORE:
Multi-axis Acceleration Sensor Module "A" Circuit Voltage Out of Range (C05201C)
DESCRIPTION The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.
When the skid control ECU (brake actuator assembly) detects an abnormal acceleration sensor (airbag sensor assembly) signal, or the control value calculated using the accelerat
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front exhaust pipe assembly (TWC: Rear Catalyst), center exhaust pipe assembly and tail exhaust pipe a
© 2023-2026 Copyright www.tocamry.com
