Toyota Camry (XV70): Customize Parameters
CUSTOMIZE PARAMETERS
CUSTOMIZE LANE TRACING ASSIST SYSTEM
NOTICE:
Record the settings when the vehicle is brought to the workshop so they can be restored.
(a) Customizing with the multi-information display
(1) Turn the ignition switch to ON.
(2) Change the setting of the lane tracing assist system by operating the customize switch (steering pad switch).
HINT:
Each lane tracing assist system item is displayed on the "Setting" tab on the multi-information display.
Lane Tracing Assist System Setting|
Display | Content |
Setting |
|---|---|---|
| Lane Center |
Select on/off for the lane centering function |
On/Off |
| Warning Sensitivity |
Select the warning timing for the lane departure warning function |
High/Standard |
|
Sway Warning | Select on/off for the vehicle sway warning function |
On/Off |
| Sway Sensitivity |
Select the warning sensitivity for the sway warning function |
High/Standard/Low |
HINT:
Some lane tracing assist system functions are available only when other functions are operating or enabled. When the following switch and operating conditions are met, each of the lane tracing assist system functions are enabled.
|
All-speed Dynamic Radar Cruise Control System |
LTA Switch | Steering Assist |
Lane Center | Sway Warning | |
|---|---|---|---|---|---|
|
●: System operating
○: Enabled | |||||
| Lane Departure Warning Function |
- | ○ |
- | - |
- |
| Steering Assist Function |
- | ○ |
○ | - |
- |
| Lane Centering Function |
● | ○ |
○ | ○ |
- |
| Vehicle Sway Warning Function |
- | - |
- | - |
○ |
READ NEXT:
Utility
UTILITY NOTICE: When the forward recognition camera has been replaced due to a lane tracing assist system malfunction, failure to adjust the forward recognition camera optical axis may affect all the
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
NOTICE:
When replacing the forward recognition camera, replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the infor
Terminals Of Ecu
TERMINALS OF ECU
NOTICE:
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.
SEE MORE:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK FOR DTC (a) Check for DTCs (Test Failed / Pending / Confirmed). Chassis > Lane Control > Trouble Codes
Techstream Display Description
Test Failed Shows the malfunction judgment results during the current trip.
Pending Shows the malfunction ju
Stop Lamp Relay Actuator Stuck Off (C13807F)
DESCRIPTION Refer to DTC C13807E. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
C13807F Stop Lamp Relay Actuator Stuck Off
When the voltage at the +BS terminal is between 10 V or more and the stop light control relay (stop light switch ass
