Toyota Camry (XV70): Electric Parking Brake Actuator
READ NEXT:
COMPONENTS ILLUSTRATION
*1 NO. 2 PARKING BRAKE WIRE ASSEMBLY
*2 PARKING BRAKE ACTUATOR ASSEMBLY
*3 O-RING
- -
Tightening torque for "Major areas in
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT PARKING BRAKE ACTUATOR ASSEMBLY (a) With the ignition switch ON and the wheels not contacting the ground, operate the electric parking brake switch assembl
REMOVAL CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. PRECAUTION Click here
2. RELEASE PA
SEE MORE:
COMPONENTS ILLUSTRATION
*1 FRONT LOWER NO. 1 FLOOR HEAT INSULATOR
- -
N*m (kgf*cm, ft.*lbf): Specified torque
- - ILLUSTRATION
*1 PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
*2 CENTER NO. 2 SUPPORT BEARING WASHER
Tight
DESCRIPTION This DTC is stored when the engine does not start even though the STA signal is input or when the engine takes a long time to start, and when the engine speed is low or the engine stalls just after the engine starts.
Using the Techstream, the conditions present when the DTC was stored