Toyota Camry (XV70): Front Camera
- Components
- Removal
- Installation
- Before Starting Target Adjustment
- Target Adjustment(one Time Recognition)
- Target Adjustment(sequential Recognition)
- Before Starting Driving Adjustment
- Driving Adjustment
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 FORWARD RECOGNITION CAMERA
*2 FORWARD RECOGNITION LATCH
*3 NO. 1 FORWARD RECOGNITION COVER
*4 NO. 2 FORWARD RECOGNITION COVER
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during forward recognition camera
Installation
INSTALLATION PROCEDURE 1. INSTALL FORWARD RECOGNITION CAMERA
NOTICE:
When replacing the forward recognition camera, replace it with a new one.
If the forward recognition camera has been str
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 CYLINDER HEAD GASKET
(a) Place a new No. 2 cylinder head gasket on the cylinder block sub-assembly as shown in the illustration.
*a Lot No.
Front of Engine
NOTICE:
Remove any oil from the contact surfaces.
Make sure t
Inspection
INSPECTION PROCEDURE 1. INSPECT AIR FUEL RATIO SENSOR (for Bank 1)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified Condition
1 (HA1A) - 2 (+B)
20°C (68°F) 1.6 to 3.2 Ω
© 2023-2025 Copyright www.tocamry.com
