Toyota Camry (XV70): Front Stabilizer Bar
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*A for A25A-FKS
*B for 2GR-FKS
*1 FRONT NO. 1 STABILIZER BAR BUSHING
*2 FRONT NO. 1 STABILIZER BRACKET LH
*3 FRONT NO. 1 STABILI
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during f
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT STABILIZER LINK ASSEMBLY
(a) Inspect the turning torque of the ball joint. (1) Secure the front stabilizer link assembly in a vise using aluminum plates.
SEE MORE:
Components
COMPONENTS ILLUSTRATION
*1 ENGINE OIL PRESSURE SWITCH ASSEMBLY
*2 FRONT FENDER APRON SEAL RH
*3 WIRE HARNESS PROTECTOR
- -
N*m (kgf*cm, ft*lbf): Specified torque
Adhesive 1344
★ Precoated part
- -
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE MAGNET STARTER SWITCH ASSEMBLY
(a) Remove the nut and disconnect the field coil lead wire from the magnet starter switch assembly.
(b) While holding the magnet starter switch assembly to the repair service starter kit, remove the 2 nuts.
© 2023-2026 Copyright www.tocamry.com
