Toyota Camry owners & service manuals

Toyota Camry (XV70): Installation

INSTALLATION

PROCEDURE

1. INSTALL BATTERY

(a) Install the battery to the vehicle.

(b) Install the No. 2 battery clamp to the battery clamp sub-assembly with the bolt.

Torque:

18.5 N

    READ NEXT:

     2gr-fks Coolant

    ComponentsCOMPONENTS ILLUSTRATION *1 RADIATOR CAP SUB-ASSEMBLY *2 RADIATOR DRAIN COCK PLUG *3 NO. 1 ENGINE UNDER COVER - - ReplacementREPLACEMENT CAUTION / NOT

     2gr-fks Drive Belt

    ComponentsCOMPONENTS ILLUSTRATION *1 FRONT FENDER APRON SEAL RH *2 V-RIBBED BELT RemovalREMOVAL PROCEDURE 1. REMOVE FRONT WHEEL RH Click here 2. REMOVE FRONT FENDER APRON

     2gr-fks Oil And Oil Filter

    SEE MORE:

     Pressure Control Solenoid "A" Circuit Short to Ground or Open (P074514)

    DESCRIPTION Refer to DTC P074512. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P074514 Pressure Control Solenoid "A" Circuit Short to Ground or Open While the vehicle is being driven so that gear changes occur,

     Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)

    CAUTION / NOTICE / HINT NOTICE: After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and system information memorization. Click here PROCEDURE 1. PRE-INSPECTION (a) Brake pedal inspection (1) Perform a visual inspec

    © 2023-2026 Copyright www.tocamry.com