Toyota Camry (XV70): Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here
PROCEDURE
1. INSTALL SPARK PLUG
HINT:
Perform "Inspection After Repair" after replacing a spark plug.
Click here
(a) Install the 4 spark plugs to the cylinder head sub-assembly.
Torque:
20 N
READ NEXT:
ComponentsCOMPONENTS ILLUSTRATION
*1 AIR FILTER COVER PLATE
*2 CLEAN AIR FILTER
*3 LOWER INSTRUMENT COVER LH
*4 AIR FILTER CASE
*5 AIR FILTER SUB-ASSEMB
ComponentsCOMPONENTS ILLUSTRATION
*1 BACK-UP LIGHT BULB
*2 LUGGAGE COMPARTMENT DOOR COVER RemovalREMOVAL CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH si
ComponentsCOMPONENTS ILLUSTRATION
*1 BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY
- - ILLUSTRATION
*A except 2-Pot Caliper
*B for 2-Pot Caliper
SEE MORE:
TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY)
(a) Disconnect the q1 sliding roof ECU (sliding roof drive gear assembly) connector.
(b) Measure the resistance and voltage according to the value(s) in the table below.
HINT: Measure the values on the wire harness
DIAGNOSTIC TROUBLE CODE CHART Dynamic Radar Cruise Control System
DTC No. Detection Item
DTC Output from Link
P057113 Brake Switch "A" Circuit Open
Cruise Control
P057162 Brake Switch "A" Signal Compare Failure
Cruise Control
P