Toyota Camry (XV70): Installation
Toyota Camry Repair Manual XV70 (2018-2024) / Brake / Brake System (other) / Brake Master Cylinder / Installation
INSTALLATION
PROCEDURE
1. INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD
Click here .gif)
2. INSTALL BRAKE MASTER CYLINDER O-RING
(a) Install a new brake master cylinder O-ring to the brake master cylinder sub-assembly.
3. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
NOTICE:
When installing a new brake master cylinder sub-assembly, remove the protectors from the master cylinder piston and outlet ports.
(a) Install the brake master cylinder sub-assembly to the brake booster assembly with the 2 nuts.
Torque:
12.5 N
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 BRAKE LINE
*2 BRAKE MASTER CYLINDER SUB-ASSEMBLY
Tightening torque for "Major areas involving basic vehicle performance such as moving/tur
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during br
SEE MORE:
Rear Window Defogger System does not Operate
DESCRIPTION When the rear window defogger switch on the air conditioning control assembly is pressed, the operation signal is transmitted to the air conditioning amplifier assembly via LIN communication. When the air conditioning amplifier assembly receives the signal, it turns on the DEF relay to o
Fuel Level Sensor "A" Signal Stuck In Range (P04602A)
DESCRIPTION Refer to DTC P046012. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Memory
Note P04602A
Fuel Level Sensor "A" Signal Stuck In Range
The change in the fuel sender gauge value is below the threshold when a certain
© 2023-2026 Copyright www.tocamry.com
