Toyota Camry (XV70): Navigation Antenna
READ NEXT:
COMPONENTS ILLUSTRATION
*A w/o Manual (SOS) Switch
*B w/ Manual (SOS) Switch
*1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
*2 NAVIGATION ANTENNA ASSEMBLY
*3
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during n
INSPECTION PROCEDURE 1. INSPECT NAVIGATION ANTENNA ASSEMBLY (w/o Manual (SOS) Switch)
(a) Check that the navigation antenna assembly cable is properly installed and does not have any sharp bends, pi
SEE MORE:
INSTALLATION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY
(a) Secure the steering knuckle between aluminum plates in a vise. NOTICE:
Do not overtighten
INSPECTION PROCEDURE 1. INSPECT STEERING HEATER SWITCH
(a) Remove the steering heater switch. Click here
*a Component without harness connected
(Steering Heater Switch)
(b) Measure the resistance according to the value(s) in the table