Toyota Camry (XV70): Sliding Roof System
Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Exterior / Sliding Roof / Convertible / Sliding Roof System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Sensor (Motor) Failure (B2341,B2344)
- Switch Failure (B2342)
- Position Initialization Incomplete (B2343)
- Remote Control System does not Operate
- Key-off Operation Function Operates even if Operating Conditions are not Satisfied
- Sliding Roof does not Move by Operating Sliding Roof Control Switch
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the
Parts Location
PARTS LOCATION ILLUSTRATION
*1 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (for LH)
*2 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (for RH)
*3 SLIDING ROOF SWITCH (ROOF
System Diagram
SYSTEM DIAGRAM
Communication Table
Sender Receiver
Signal Line
Main Body ECU (Multiplex Network Body ECU)
Sliding Roof ECU (Sliding Roof Drive Gear Sub-assembly)
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine unit removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/R
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft assembly removal/installation are shown below. Necessary Procedures After Parts Rem
© 2023-2026 Copyright www.tocamry.com
