Toyota Camry (XV70): When trouble arises
Toyota Camry Owner's Manual XV70 (2017-2024) / When trouble arises
- Essential information
- Emergency flashers
- If your vehicle has to be stopped in an emergency
- If the vehicle is submerged or water on the road is rising
- Steps to take in an emergency
- If your vehicle needs to be towed
- If you think something is wrong
- Fuel pump shut off system
- If a warning light turns on or a warning buzzer sounds
- If a warning message is displayed
- If you have a flat tire
- Taking out the spare tire
- Replacing a flat tire
- Installing the spare tire
- If the engine will not start
- If the electronic key does not operate properly (vehicles with a smart key system)
- If the vehicle battery is discharged
- If your vehicle overheats
- If the vehicle becomes stuck
READ NEXT:
Emergency flashers
The emergency flashers are used to warn other drivers when the
vehicle has to be stopped on the road due to a breakdown, etc.
Press the switch.
All the turn signal lights will flash.
To turn t
If your vehicle has
to be stopped in
an emergency
Only in an emergency, such as if it becomes impossible to stop
the vehicle in the normal way, stop the vehicle using the following
procedure:
1. Steadily step on the brake pedal with both feet and
SEE MORE:
Master Module Horizontal Axis Misalignment (C1AC1)
DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis.
HINT:
If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monito
Brake Switch "A"/"B" Signal Cross Coupled (P05042B)
DESCRIPTION The stop light switch assembly is a duplex system that transmits two signals: STP and ST1-. These two signals are used by the ECM to monitor whether or not the brake system is working properly. If the signals, which indicate the brake pedal is being depressed and released, are detected s
© 2023-2026 Copyright www.tocamry.com
